Why Switch Joy-Con Silicone Caps Fit Most Anbernic & Retroid Sticks (With One 0.5mm Catch)
One of the most common questions we see from new Anbernic (RG476H, RG406H, RG40XX, RG35XX H/SP) and Retroid Pocket owners is whether standard Nintendo Switch Joy-Con thumbstick grips (such as Skull & Co., GeekShare, or Poké Ball silicone caps) fit aftermarket Hall-effect analog sticks.
The short answer: Yes — standard Switch Joy-Con caps fit, but stock Anbernic and Retroid Hall-effect stick tops are roughly 0.4mm to 0.5mm narrower in diameter and slightly thinner at the lip than an OEM Nintendo Joy-Con cap. That means stiff multi-claw caps lock on immediately, while softer decorative silicone caps can twist or rotate under heavy thumb pressure during fighting games or 3D platformers.
The 30-Second Tape Shim Trick That Stops Cap Rotation
- Step 1: Wipe the top of the stock Anbernic/Retroid Hall-effect cap with 70%+ isopropyl alcohol so skin oils don't lubricate the inside of the silicone dome.
- Step 2: Cut a tiny 6mm × 6mm square of thin double-sided Scotch tape (or a single layer of matte electrical tape) and press it flat onto the top center of the stock stick cap.
- Step 3: Flip your Switch Joy-Con silicone cap inside-out, center it over the stick, and roll the skirt down around the underside lip. It will lock rock-solid with zero rotation and leaves no permanent adhesive residue if you remove it later.
Day-One Rule: Replace the Stock Unbranded microSD Card
Whether you buy a $45 Linux handheld or a $180 Android emulator, never keep your BIOS and save files on an unbranded factory microSD card. Unbranded cards bundled with budget handhelds suffer high sector-corruption rates within 30 to 60 hours of write cycles. Swap immediately to a name-brand UHS-I U3 / V30 A2 microSDXC card (SanDisk Extreme/Ultra, Samsung EVO Select/Pro Plus, or Lexar Play) when 256GB dips below $22 or 512GB dips below $36.

